Fanuc Tüm modeller 413 kodu

Anlamı

The contents of the error register for the n-th axis (axis 1-8) exceeded ±231 power. This error usually occurs as the result of an improperly set parameters

Olası nedenler

The contents of the error register for the n-th axis (axis 1-8) exceeded ±231 power. This error usually occurs as the result of an improperly set parameters

Tüm modeller için diğer kodlar

• 253M series;Alarm details Binary input operation using high-speed remote buffer (G05) or high- speed cycle machining (G05) has been specified in advance control mode (G08P1). Execute G08P0, to cancel advance control mode, before executing these G05 commands
• 400The n-th axis (axis 1-4) overload signal is on. Refer to diagnosis display No. 200, 201 for details
• 405Position control system fault. Due to an NC or servo system fault in the reference position return, there is the possibility that reference position return could not be executed correctly. Try again from the manual reference position return
• 409Abnormal load has been detected on the servo motor(s). Alternatively, abnormal spindle motor load has been detected in Cs mode
• 414N-th axis (axis 1-4) digital servo system fault. Refer to diagnosis display No. 200, 201, and No.204 for details
• 415A speed higher than 524288000 units/s was attempted to be set in the n-th axis (axis 1-8). This error occurs as the result of improperly set CMR
• 416Position detection system fault in the n-th axis (axis 1-4) pulse coder (disconnection alarm). Refer to diagnosis display No. 200, 201 for details
• 4530The number for storing and calling by an A or B macro was set to a value beyond the range from 1 to 5