Ghibli endüstriyel süpürge Error-Codes UA11 kodu

Anlamı

Open phase error- Loss of motor phase during operation Motor not connected- Motor disconnected during operation

Olası nedenler

1. Verify connections going to the inverter and to the motor. 2. Verify the windings on the motor are good. Wind to wind should be about the same. Wind to chassis and wind to klixon should be open. 3. Verify amperage draw on each leg of the output side (motor side) of the inverter. Amperage draw should be about the same. 4. Possible bad inverter

Error-Codes için diğer kodlar

• U-39Inverter fault- Fault in inverters internal control
• U-41Inverter to motor fault - A fault in one of the three inverter/ motor output phases
• U-50Short detected in the motor windings- A short in the motor or motor winding. This could be a short phase to phase, phase to housing, or phase to klixon
• U-56
• UA13ADC hardware error- Inverter has failed Electronic circuit error- Internal component of the inverter is damaged Inrush current failure- Inverter has failed
• UA14Over current diversion- Inverter is detecting an over current situation
• UA16Inverter overcurrent error-
• UA17Inverter overload error- Excessive motor consumption Motor over temperature error Motor over temperature