Immergas Victrix 26 2 I P4 kodu

Anlamı

The boiler is set-up for functioning with the relay board (optional), which can be configured 0 = Off 1 =General alarm 2 = CH phase active 3 = External gas valve power supply 4 = Secondary zone control (from TA on relay board contact 5 = Heat pump

Victrix 26 2 I için diğer kodlar

• M303-way valve (motorised)
• P0Establishes the switch-of fmethod in DHW mode. 1 Correlated: the boiler switches off on the basis of the temperature set.
• P2The pump can function in two ways. 0 intermittent: In winter "mode" the pump is managed by the room thermostat or by the remote control 1 continuous: In "winter" mode the pump is always powered and so functions continuously
• P3The boiler is set-up for functioning with the relay board (optional), which can be configured 0 = Off 1 = Main zone control 2 =General alarm 3 = CH phase active 4 = External gas valve power supply 5 = (Do not use on this boiler model)
• P5The boiler is set-up for functioning with the relay board (optional), which can be configured 0 = Off 1 = Chiller remote activation 2 =General alarm 3 = CH phase active 4 = External gas valve power supply 5 = heat pump 6 = activation of storage tank pump
• R5Domestic hot water temperature trimmer
• R6Central heating temperature trimmer
• S0The boiler also has electronic modulation that adapts the boiler potentiality to the efef ctive heating demand of the house. Teh refore the boiler works normally in a variable gas pressure fei ld between minimum and maximum power depending on the system heat load, setting fan speed (in rpm, hundreds of revs are represented on the display). N.B.:the boiler is produced and calibrated in the central heating phase at nominal output. Approximately 10 minutes are needed to reach the nominal heat output, which can be changed using the parameter (S3). N.B.: selection of parameters in the presence of requests, allows boiler functioning with current equal to the respective value

P4 kodu diğer Immergas modellerinde

• P4Tüm modellerTeh boiler is set-up for functioning with the relay board (optional), which can be configured 0 = Off 1 =General alarm 2 = CH phase active 3 = External gas valve power supply 4 = Secondary zone control (from TA on relay board contact 5 = Heat pump